Conveyor

A Drag Chain Conveyor is a conveyor in which the open links of chain drag material along the bottom of a hard faced MS or SS trough. It generally have a low bed height and are open type.

The flights are fixed between two strands of chain, drags the material from feeding end to the discharge end in open or closed trough. These are available in difference widths and lengths as per the site requirements and are also used for handling slightly sluggish, loose or lumpy hot material.
Generally these conveyors are easy to install and have very minimum maintenance for the clients. These are available in different widths and lengths as per the clients/site requirements. These conveyors are dust proof, low noise and sealed design.

These are most commonly for transporting /feeding fine material. Bs Engineering can supply screw conveyors of size ranges from 150 TO 1500mm diameter screw flights with suitable length. We also supply inclined Screw Conveyors.
We have developed special design of Screw Conveyor / Feeder without hanger bearing for length of about 15 meters maximum, depending on the size of screw. We regularly supply such Screw Conveyors without Hanger bearings to several customers.
Bs Engineering Screw Conveyor is of simple design, easy to maintain, of small width, permits intermediate discharge of the material at several points. They can be used for the horizontal as well as for the ascending conveying (approx. 20 deg.). Because of design simplicity permits fabrication from a wide variety of material to resist heat, Corrosion or abrasion. It is adopted easily to dust tight construction.
They are supplied in a assembled form except drive unit, chain, sprockets which is send separately. At site the unit is placed and drive unit and gearbox attached with the help of coupling.

The flights are fixed between two strands of chain, drags the material from feeding end to the discharge end in open or closed trough. These are available in difference widths and lengths as per the site requirements and are also used for handling slightly sluggish, loose or lumpy hot material.
Generally these conveyors are easy to install and have very minimum maintenance for the clients. These are available in different widths and lengths as per the clients/site requirements. These conveyors are dust proof, low noise and sealed design.

A transversing, bidirectional steel belt conveyor is designed for final load-out of stamping scrap into large trailers or railcars.

Continuous, back and forth, operation provides for even distribution into larger scrap containers where swivel chute systems would be inadequate.

We manufacture a flexible range of Tripper Conveyors developed using high quality advanced components and are in conformation with various international quality standards. It can either be fixed position or movable and consists of a structure with two pulley assemblies. Several powered drive options and chute configurations are available for any belt tripper.